|
|
|
Port wingtip flange distortion: 2008-03-28
Nikon Coolpix 8400
Looking forward along the edge of the port wing tip moulding towards the spar and forward skin. The flange of the tip moulding is not level, but has been bonded to the forward skin at a slight angle. Note the Redux layer between flange and skin is thick at the left and tapers down to nothing at the right. This tilt prevents the top skin (withdrawn to the right in this picture) from bedding down properly. There was no such problem with the starboard wing tip, so I don't have a good comparative picture.
 go to previous picture page
|
 back to journal page
|
go to next picture page
|
 go to list of photo pages
|
| This page last updated 2008-05-03. I try to make this page as accessible as possible, by adhering to HTML 4 standards. |
|
|
| I welcome comments on this website. However, because of the amount of spam it attracts, I no longer post a direct e-mail address on this page. Instead, please click here to contact me using my i-name =Rowland.Carson. You will have to confirm that the message is genuine before it will be sent on to me. | ||