|
|
|
AN842-4D won't fit: 2009-03-11
Nikon Coolpix 8400
The AN842-4D elbow I intended to use for the fuel sight gauge connexion is much too long to fit - it's just touching the seat-back - and I don't want to angle it upwards because the tube might have to curve down again before passing through the seat-back, and that might cause air-locks.
fuel tank adaptors: 2009-03-11
Nikon Coolpix 8400
The fuel tank adaptors fitted, with the straight brass adaptor (as supplied in the kit) fitted for the sight gauge tubing instead of the AN842-4D elbow I planned to use.
fuel tank adaptor clearance: 2009-03-11
Nikon Coolpix 8400
There is not much clearance between the fuel tank outlet and the transverse pitch torque tube CS10, but at least they are not rubbing!
 go to previous picture page
|
 back to journal page
|
go to next picture page
|
 go to list of photo pages
|
| This page last updated 2009-04-02. I try to make this page as accessible as possible, by adhering to HTML 4 standards. |
|
|
| I welcome comments on this website. However, because of the amount of spam it attracts, I no longer post a direct e-mail address on this page. Instead, please click here to contact me using my i-name =Rowland.Carson. You will have to confirm that the message is genuine before it will be sent on to me. | ||