|
|
|
bonding clip for sight gauge tubing: 2009-04-28
Nikon Coolpix 8400
The U-shaped clip for securing the sight gauge tubing was made earlier from 2 layers of BID laid up on a former (an M12 bolt). Here it is being bonded with Redux onto the seat-back in the correct position to retain the tubing on its way between the fuel tank fitting (at upper left, hidden here) and the hole beside the tunnel at lower right. The clip is held down by a mushroom-shaped lead weight, and a wooden bridge interposed allows the weight to be applied to the flanges without distorting the U-section.
 go to previous picture page
|
 back to journal page
|
go to next picture page
|
 go to list of photo pages
|
| This page last updated 2009-06-19. I try to make this page as accessible as possible, by adhering to HTML 4 standards. |
|
|
| I welcome comments on this website. However, because of the amount of spam it attracts, I no longer post a direct e-mail address on this page. Instead, please click here to contact me using my i-name =Rowland.Carson. You will have to confirm that the message is genuine before it will be sent on to me. | ||