|
|
|
Making clips for stall-warner tube: 2007-08-31.
Nikon Coolpix 8400
2 Layers of BID draped over a 6mm rod and weighed down each side with pieces of wood to form the flanges of the clips. The BID was covered with peel-ply and layers of polyethylene were used top & bottom to stop the layup sticking to either the rod or the wood.
Making clips for stall-warner tube: 2007-09-03.
Nikon Coolpix 8400
Here's the resulting layup after cure and removal of peel-ply and polyethylene sheet. The edges (as with many layups on polyethylene) are a bit dangerous, with glass needles sticking out in places, so will get trimmed off very soon.
 go to previous picture page
|
 back to journal page
|
go to next picture page
|
 go to list of photo pages
|
| This page last updated 2008-05-03. I try to make this page as accessible as possible, by adhering to HTML 4 standards. |
|
|
| I welcome comments on this website. However, because of the amount of spam it attracts, I no longer post a direct e-mail address on this page. Instead, please click here to contact me using my i-name =Rowland.Carson. You will have to confirm that the message is genuine before it will be sent on to me. | ||