|
|
|
fuel valve trial assembly: 2009-02-02
Nikon Coolpix 8400
The fuel valve temporarily assembled on its plywood mounting plate and connected to the selector by the extension shaft. The green felt-tip pen marks a little further up the tunnel wall show the first proposed mount position, before I modified the tube bender to allow bends closer to the flared end. This final position of the mounting plate brings the ends of the AN822-6D elbows just clear of the narrow part of the tunnel and so improves access for fitting the pipes.
 go to previous picture page
|
 back to journal page
|
go to next picture page
|
 go to list of photo pages
|
| This page last updated 2009-03-08. I try to make this page as accessible as possible, by adhering to HTML 4 standards. |
|
|
| I welcome comments on this website. However, because of the amount of spam it attracts, I no longer post a direct e-mail address on this page. Instead, please click here to contact me using my i-name =Rowland.Carson. You will have to confirm that the message is genuine before it will be sent on to me. | ||