|
|
|
Fitting fuel valve mount: 2009-02-17
Nikon Coolpix 8400
The glass-reinforced plywood mount for the fuel valve has previously been epoxied into position, and now BID flanges have been laid up on each side and both faces to support those joints properly. The layups are covered with peel-ply. A block of wood covered with polyethylene sheet is clamped in place to prevent the layups from encroaching onto the central area where the valve must fit flush against the mounting plate.
 go to previous picture page
|
 back to journal page
|
go to next picture page
|
 go to list of photo pages
|
| This page last updated 2009-04-02. I try to make this page as accessible as possible, by adhering to HTML 4 standards. |
|
|
| I welcome comments on this website. However, because of the amount of spam it attracts, I no longer post a direct e-mail address on this page. Instead, please click here to contact me using my i-name =Rowland.Carson. You will have to confirm that the message is genuine before it will be sent on to me. | ||