|
|
|
TE flap-aileron junction: 2008-04-04
Nikon Coolpix 8400
The area between the aileron and flap on the port wing. For proper fitting of the flap, the flange of the TE which covers the flap needs to be able to move a bit from its manufactured position. It is constrained at its outboard end by a vertical piece. On advice from the factory, I cut this away to allow the wing TE to move either up or down as required for the top skin fitting with the flap in place.
TE flap-aileron junction: 2008-04-04
Nikon Coolpix 8400
Cutting away the vertical part that constrains the TE over the flap.
TE flap-aileron junction: 2008-04-04
Nikon Coolpix 8400
The aileron-flap junction with the small vertical piece cut away.
 go to previous picture page
|
 back to journal page
|
go to next picture page
|
 go to list of photo pages
|
| This page last updated 2008-05-03. I try to make this page as accessible as possible, by adhering to HTML 4 standards. |
|
|
| I welcome comments on this website. However, because of the amount of spam it attracts, I no longer post a direct e-mail address on this page. Instead, please click here to contact me using my i-name =Rowland.Carson. You will have to confirm that the message is genuine before it will be sent on to me. | ||