|
|
|
bonding CS02 and CS03: 2008-08-19
Nikon Coolpix 8400
To keep both CS02 bearing faces horizontal while bonding in the CS03s, I clamped the CS02s together with a couple of pieces of wood. Note that the screws of the g-cramps are on opposite sides for balance. There are sheets of polyethylene interposed between the CS04s and the CS03s, and between the CS04s and CS02s to provide a small clearance. The lead weights keep all the bearing surfaces parallel during cure of the Redux.
bonding CS02 and CS03: 2008-08-19
Nikon Coolpix 8400
The CS02 - CS03 bonding arrangement, with the lead weights removed. The sheets of polyethylene have holes cut to natch the bore of the CS04s, and are slit to allow easy removal after the bond has cured. The slits are bridged with masking tape to keep the polyethylene in position.
bonding CS02 and CS03: 2008-08-19
Nikon Coolpix 8400
The CS02 - CS03 bonding arrangement after removal of the polyethylene sheets.
 go to previous picture page
|
 back to journal page
|
go to next picture page
|
 go to list of photo pages
|
| This page last updated 2008-08-31. I try to make this page as accessible as possible, by adhering to HTML 4 standards. |
|
|
| I welcome comments on this website. However, because of the amount of spam it attracts, I no longer post a direct e-mail address on this page. Instead, please click here to contact me using my i-name =Rowland.Carson. You will have to confirm that the message is genuine before it will be sent on to me. | ||