|
|
|
turning brake filler cover: 2008-08-07
Nikon Coolpix 8400
A billet of aluminium offset in the 4-jaw chuck for turning the spigot of the brake filler cover. The piece of rectangular section aluminium at the back was needed not only to improve the balance but also to allow the jaws to grip on this very eccentric workpiece.
rough-cut brake filler cover: 2008-08-07
Nikon Coolpix 8400
The cover for the brake filler hole cut roughly to outline, sitting on top of the billet of aluminium from which it was made.
brake filler cover fitting: 2008-08-07
Nikon Coolpix 8400
The finished brake filler hole cover (upside-down) showing the mounting arrangment.
brake filler cover fitted: 2008-08-07
Nikon Coolpix 8400
The brake filler hole cover fitted.
 go to previous picture page
|
 back to journal page
|
go to next picture page
|
 go to list of photo pages
|
| This page last updated 2008-08-31. I try to make this page as accessible as possible, by adhering to HTML 4 standards. |
|
|
| I welcome comments on this website. However, because of the amount of spam it attracts, I no longer post a direct e-mail address on this page. Instead, please click here to contact me using my i-name =Rowland.Carson. You will have to confirm that the message is genuine before it will be sent on to me. | ||