left-arrow
Search for words on this site: powered by FreeFind
right-arrow

3D Mouldings label in bonding area

port wing label

port wing label: 2008-01-30.

Nikon Coolpix 8400

I thought this port wing serial-number label was under the top layer of glass on the bottom skin, but when I came to abrade the area for the aileron closeout I found it was on the surface, so it had to come off.


label removed

label removed: 2008-01-30.

Nikon Coolpix 8400

Here's the same area with all the residue of the label removed. The strong blue colour on the aileron closeout towards the right-hand side of this picture is the edge of the BID on the hinge reinforcement inside the closeout. To make cutting them out easier and more accurate, I mark all my glass pieces for cutting with a felt-tip pen. The edge remains visible after the layup is completed, which is helpful to confirm that the layups extend over the required area.

left-arrowgo to previous picture page notepadback to journal page notepad go to next picture page right-arrow
listgo to list of photo pages list

Return to Rowland's home page


This page last updated 2008-05-03. I try to make this page as accessible as possible, by adhering to HTML 4 standards. Valid HTML 4.01! Valid CSS!
I welcome comments on this website. However, because of the amount of spam it attracts, I no longer post a direct e-mail address on this page. Instead, please click here to contact me using my i-name =Rowland.Carson. You will have to confirm that the message is genuine before it will be sent on to me.